Close MenuJAHN BRACKETS
The AR A-Clamp is used to hold a horizontal waler bar, or a vertical stud with any type of wall form. The built-in slot allows the bracket to slip over 4-3/4" L&W snaptys, and can be installed before or after waler bars have been positioned. The swivel bracket allows the snapty end to lock-in and tighten on the 2 x 4 waler. The swivel bracket allows for 5/8" of adjustment to compensate for lumber variations
QUICKRETE PRONTO MIX 60LB
PRODUCT USE:QUIKRETE® PRONTO MIX is a construction grade mortar mix designed for laying brick, concrete masonry units and stone. QUIKRETE® PRONTO MIX is a pre-blended, sanded product. The standard formulation meets ASTM C 270 and C 1714 for Type N mortar. *YIELD : Each 80 lb (36.2 kg) bag of QUIKRETE® PRONTO MIX will lay up to 37 standard bricks or 13 standard(8 in x 8 in x 16 in [200 mm x 200 mm x 405 mm])blocks TECHNICAL DATA:APPLICABLE STANDARDS: ASTM International •ASTM C 270 Specification for Mortar for Unit Masonry•ASTM C 1714 Specification for Preblended Dry Mortar Mix for Unit Masonry *PHYSICAL/CHEMICAL PROPERTIES:QUIKRETE® PRONTO MIX meets or exceeds the property requirements of ASTM C 270 and ASTM C 1714 for the type selected. Refer to Appendix XI of ASTM C 270 for guidance in selecting the proper mortar type. INSTALLATION: *Apply a full bed of mortar onto the base, approximately1/2 in to 3/4 in (13 mm to 19 mm) thick•Push downward into the mortar bed and sideways against the previously laid block with a slight twisting motion•Tool the mortar joints when they become thumbprint hard. This will make the mortar joint watertight and provide a neat appearance *CURING:Curing of masonry mortars is required only if conditions are very hot, dry or windy. In such cases, a gentle mist of water applied to the surface will prevent premature drying and improve the strength of the mortar.PRECAUTIONS:Variations in mix water amount, mix time, curing conditions and finishing will cause color variations.
FIBER REINFORCED PRONTO MIX 40LB
FIBER-REINFORCED PRONTO MIX is a contractor grade mortar mix reinforced with multifilament nylon fibers that provides a high impact and crack resistance shell. For tougher, more durable, low maintenance plastering on concrete walls, laying brick, block or stone. Can be used for repairing cement block walls, mortars, tuck-pointing and stucco. COMPOSITION AND MATERIALS: FIBER-REINFORCED PRONTO MIX consists of a uniformly blended mixture of fine sand (C-144), masonry cement, or Portland Cement I (lime blend) and 0.50” long multi-filament nylon fibers. Proper proportions and blending are assured at the plant through patented mixing, measuring and packaging equipment designed by the QUIKRETE® Companies.
